Aluminium Tectonics- Jagdeep Sehmar

photo(1)

The sketches show alternative joining methods we explored before finalising our chosen method. Both methods consisted of using a ‘T-joint’ that would be bolted into the substructure frame. Using this we would simply bolt the two neighbouring shading devices together through the ‘T-joint’. Method 2 was a lot weaker than Method 1 due to the greater angle the aluminium sheet is bent through.

Looking at the efficiency of our product we gathered that the ‘T-joint’ is not needed if we added tabs to the shading device fins. Doing so we were able to bend these tabs to 90 degrees as shown in the final diagram.  Effectively doing the same job as the ‘T-joint’ without using excessive material.

Members in group: Jagdeep, Kimran, Stanley.

About Co.LAB Student

MArch FT5 Free city

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: